1. If the saw blade of the
TCT band saw blade grinding machine production line is not used immediately, it should be laid flat or suspended with an inner hole. Other articles or feet should not be stacked on the flat saw blade, and pay attention to moisture, Anti-corrosion.
2. When the saw blade is no longer sharp and the cutting surface is rough, it must be re-sharpened in time. Grinding cannot change the original angle and disrupt the dynamic balance.
3. The inner diameter correction of the saw blade, positioning hole processing, etc., must be performed by the manufacturer. If the processing is bad, it will affect the product's use effect and may be dangerous. In principle, the hole expansion should not exceed the original diameter of 20mm to avoid affecting the balance of stress.
Safe operation process of alloy band saw blade grinding machine:
1. Strictly abide by the safety operation rules of the gear grinding machine and wear labor protection articles as required. Before starting, you must carefully check whether the motor, switch, line and ground are normal and firm, and check that the operating parts and buttons of the device are in the correct position.
2. When the upper slide and each positioning axis are not at the origin, run the origin return procedure. Check the coincidence and firmness of the upper and lower molds; check whether each positioning device meets the requirements of being processed.
3. After the equipment is started, it will run for 1-2 minutes and run on the skateboard for 2-3 times of full stroke. If abnormal sound or malfunction is found, it should be stopped immediately, and the malfunction should be eliminated. Only after it is normal can it work.
4. When working, one person should direct the command to make the operator closely cooperate with the feeding and suppressing personnel to ensure that the cooperating personnel are all in a safe position to send the bending signal. The sheet must be compacted during bending, to prevent the sheet from lifting and hurting people during bending. It is forbidden to fold ultra-thick iron plates or hardened steel plates, high-grade alloy steels, square steels and sheets that exceed the performance of sheet gear gear grinding machines to avoid damage to the gear grinding machines.
5. The power supply must be cut off when adjusting the plate material and pressing the mold, and then the operation is stopped. When changing the opening of the variable lower die, no material is allowed to contact the lower die.
6. It is found that the workpiece or mold is not correct during operation, and it should be stopped for correction. It is strictly prohibited to correct by hand during operation to prevent injury to the hand. When the gear grinding machine is working, no one is allowed to stand behind the gear grinding machine.
7. Regularly check the coincidence of the upper and lower molds; whether the indication of the pressure gauge meets the regulations. If an abnormality occurs, it will immediately shut down, check the cause and eliminate it in time.
8. Before shutting down, first exit the control system program, and then cut off the power. Place a wooden block on the lower mold below the cylinders on both sides to lower the upper slide onto the wooden block.