1. Installation saw blade
Measure the outer diameter of the saw blade and the center hole, select the centering washer, install the saw blade on the saw blade seat, and then lock it with the knurled nut of the saw blade seat, then loosen the saw blade seat locking screw, and then move the saw blade Seat, align the outer diameter of the saw blade with the corresponding scale of the saw blade seat, and then tighten the screw. If the saw blade has broken teeth or when new teeth are made, the grinding guide must be used. Generally speaking, it is easier to grind with the grinding guide, and the grinding guide should be used as much as possible.
2. Rotating tightness adjustment of circular saw blade
If the rotation of the saw blade is not properly tightened, the forward displacement of the saw blade will be inaccurate at this time. Therefore, after the saw blade is installed, rotate the circular saw blade counterclockwise with your left hand and try the tightening of the rotation. If the tightening is not appropriate, use M17 open-end wrench adjusts the anti-loosening nut to make the saw blade rotate properly.
The principle of tightness is to eliminate the inertia of the saw blade rotation and the impact of the grinding wheel, not too tight.
3. Saw blade thickness adjustment
In order to make the grinding of the saw teeth even up and down, the center of the grinding wheel and the thickness center of the saw blade should be in a straight line.
4. Cutting angle adjustment
Since the material to be cut by the saw blade varies greatly, the appropriate cutting angle should be selected according to the material to be cut. Cut the angle, and then tighten the clamping seat screw.
5. Tooth shape transformation
Generally, there are two types of teeth, one is triangular teeth, and the other is curved teeth. The tooth type should be determined before grinding. To change the tooth profile when the machine is running, use the L-shaped wrench to change the tooth profile change button to select the tooth profile to be ground.
When purchasing our equipment, we have already adjusted it for our customers. Customers only need to select the grinding guide and the distance between the saw blade seat and the grinding wheel according to their own saw blade. The normal operation is as follows:
1. After adjusting the above distance, balance the push and grip with the swing arm. It is advisable to have two fingers between the push and grip and guide grinding disc and the grinding wheel.
2. Next, turn on the power and pay attention to the changes in the high-speed gear. It is better to be slow when aligning the gears, and lower the nose evacuation lever for the stability of the gears.
3. Adjust the push and grasp adjustment rod, and push the push and grasp and the guide plate strongly.
4. Adjust the tooth adjustment lever, and the front and rear angles are just ground after adjustment.
5. Adjust the tooth depth adjustment rod as needed to grind the saw blade tooth shape.
6. The chamfering only needs to move the machine head up and down by 150 degrees, and the guide disc can be adjusted by 2 teeth.