Welcome to LDX official website!

Foshan Li Dexin Machinery Manufacturing Co., Ltd.
Foshan Li Dexin Machinery Manufacturing Co., Ltd.

 WeChat

Foshan Li Dexin Machinery Manufacturing Co., Ltd.

Foshan Li Dexin Machinery Manufacturing Co., Ltd.

Specializing in the production of TCT circular saw blades, TCT band saw blades, finger joint knives, flying knives, various non-standard CNC grinding machine production lines

Check category

The tool of the saw grinding machine should have the following characteristics

  • Time of issue:2019-07-27 20:41

(Summary description)The tool of the saw grinding machine should have the following characteristics


The tool of the saw grinding machine should have the following characteristics

(Summary description)The tool of the saw grinding machine should have the following characteristics


  • Time of issue:2019-07-27 20:41
The tool of the saw grinding machine should have the following characteristics
 
 
 
(1) It has high precision, durability, stable geometric shape and small change.
 
(2) The tool can realize the pre-modulation and quick tool change of the machine. When machining the high-precision hole, the tool size of the bevel gear milling machine should be determined through trial cutting.
 
(3) The handle of the tool should meet the requirements of the handle standard.
 
(4) Control the breaking and discharging of the chips well.
 
(5) Has good cooling performance.
 
What should you pay attention to when maintaining the saw gear grinding machine?
 
    In view of the fully numerical control standard of the worm wheel grinding machine, it is a machine tool that integrates mechanical, hydraulic and electrical system control. The coordination performance of various electrical components and hydraulic unit parts is obviously optimized, and complement each other. Impact, for the maintenance of the usual performance in use, the main points are as follows:
 
 
    First, the maintenance of the hydraulic system For the maintenance of the hydraulic system, when the machine tool is used for a period of time, the viscosity of the hydraulic oil and other performance indicators will be affected, the cleanliness of the oil will also decrease, for some more sophisticated hydraulic valves will produce significant wear Negative effect, so the hydraulic oil should be sedimented and filtered once in a month or so, and replaced once every three months. This can improve the service life of hydraulic components, and at the same time, the solenoid valves, pressure valves, throttle valves, relief valves and The pressure relay should be inspected, especially if the pressure gauge is more than ±0.5×105Pa, and the valve core must be cleaned with clean gasoline to make it work normally.
 
    Second, the electrical system maintenance electrical system is mainly some control components, such as relay output, input interface, electrical box module, cable line floor immersion oil maintenance, these components should be checked regularly, the cable line as far as possible to go overhead, Do not land, to avoid other signal interruptions.
 
    Third, the maintenance mechanism of the mechanical mechanism is mainly whether the bearing load accuracy of the bearing meets the requirements, whether the lubrication of each lubrication part is in place, try to avoid the gear burn at the high-speed running gear, and the rail lubrication is improperly caused by the guide rail.
Keyword:

CONTACT US

Tel:0086 757-82800952     Fax:0086 757-82800953 
QQ Email:1150353041@qq.com
Email:ldx@gdlidexin.com
Contact:Mr. Tu(0086 13823458229) Miss Lei(0086 13690538372
Add:No. 3, South District, Luanhe Industrial Zone, Luocun, Nanhai District, Foshan City

FOLLOW US

Foshan Li Dexin Machinery Manufacturing Co., Ltd.

Mobile website

Alibaba Mall

Foshan Li Dexin Machinery Manufacturing Co., Ltd.

WeChat

COPYRIGHT ©2020 Foshan LDX Machinery Manufacturing Co., Ltd. All Rights Reserved